Alcatel OS6400-24 Guia do Utilizador descarregar pdf (Página 57)

OmniSwitch 6400 Series Hardware Users Guide July 2010 page 3-1

3 Mounting OS6400

Switches

Note. Never obstruct the air intake or exhaust vents located on the chassis. Obstructing these vents can

cause switch failure. Always follow the recommended clearance values.

General Mounting Recommendations

Be sure that your switch is placed in a well-ventilated, static-free environment. Always allow adequate

clearance at the front, rear, top, and sides of the switch. Refer the table below for detailed information on

recommended chassis clearances.

Recommended Clearances

The following table shows the recommended minimum clearances for adequate chassis airflow and access

to cabling and components at the front and rear of the chassis.

Note. Clearance recommendations at the front and rear of chassis are for access to cabling and

components only and are not intended as a specific airflow requirement. If a redundant power supply is to

be attached directly to the rear of the switch chassis (see page 3-13), additional clearance will be required

to accommodate the power supply tray.

Location

Top No minimum clearance required. However, be sure that the top of the chassis is not in

direct contact with any equipment above.

Bottom No minimum clearance required. However, be sure that the bottom of the chassis is not in

direct contact with any equipment below.

Sides 2 inches

Rear 6 inches (see note below)

Front 6 inches (see note below)

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 151 152

Sem comentários

Alcatel OS6400-24 Guia do Utilizador Página 57